ANTIPHOAM

Antiphoam eliminates foam and suds from spas and hot tubs. A concentrated liquid silicon emulsion antiphoam is added to the water with the filtration system running in small quantities until the foam or suds disappear.​

AQUA CHECK YELLOW

AquaChek Yellow are the water testing strips that you use when you have a chlorine based water sanitation system. These strips are for pools and spas and measure pH, free chlorine, total alkalinity and cyanuric acid levels. Only the first 2, pH and chlorine are really needed for spas as the other 2 are for pools where you change the water less often and they are constantly open to sunlight. For more information go to either our full spa "Chemical Guide" or our handy "Daily Water Care" sheet.

AQUA CHECK RED

AquaChek Red are the water testing strips that you use when you have a bromine based water sanitation system. These strips are for pools and spas and measure total hardness (a proper hardness level keeps water from causing corrosion or scaling), total bromine (an ideal level of bromine keeps water sparkling), total alkalinity (correct total alkalinity prevents sudden pH changes) and pH levels (avoid corrosion and scaling).

SPA BATH CLEANER

Spa Bath cleaner is a special formula for cleaning the interior and piping of spas and hot tubs and is used to remove all bacteria, oils and other substances. Simply add to water and let the spa run through several cycles and then leave to rest. Drain and re-fill the spa letting it run again for several cycles, then drain and re-fill again.

CAL FREE

Cal Free is made from some special salts that reduce the amount of calcium in the water in spas and hot tubs. Reduction of calcium in the bath and piping prevents incrustation and subsequent oxidation prolongng both equipment and plumbing life. Please refer to our handy "Daily Water Care" sheet for further information.

DICHLOR

Dichlor 56% is a granulated, rapidly dissolving compund used for the treatment of water in pools and spas. Added directly to the water, or through the skimmer, levels should be maintained at around 2 - 5 millligrams per liter with shock levels at over 20 milligrams per liter.

BROMO TABS

Slow dissolving tablets for spa and hot tub water sanitization. Ensures that water, tubing, equipment and filters are free from bacteria build-up. Check that dosage is correct using a test kit at least twice weekly. Bromine only works effectively if the pH balance is correct

PH MINUS

pH Minus reduces levels of pH in the water if it is too high (alkaline). This product must be disolved in water before adding to the spa or hot tub. Add with pumps running for even distribution throughout the spa or hot tub. Do not test water until at least 2 hours have passed as the product takes time to work.

PH PLUS

pH Plus increases the level of pH in the water when it is too low (acidic). This product must be disolved in water before adding to the spa or hot tub. Add with pumps running for even distribution throughout the spa or hot tub. Do not test water until at least 2 hours have passed as the product takes time to work.

CRISTAL CLEAR

Crystal Clear 4-in-1 is a special product that:

• 1/ Clarifys the water
• 2/ Removes disolved metal impurities
• 3/ Eliminates body oils and scum marks
• 4/ Improves filter efficiency

Add once every 1 - 2 weeks depending on bather load.

FILTER CLEANER

Using this liquid you can effectively clean your filter without adding any soaps to your water.

Simply remove the filter and put it to soak in a bucket of water with this product added for a period of not less than 6 hours, then rinse thoroughly and replace in your spa or hot tub.

ANTI SLIP

Used to treat surfaces around pools and spas, including surfaces underwater, to make them anti-slip. After taping off and covering areas around the area to be treated simply spray uniformly onto the surface. Surfaces must be clean and grease free. Wait 3-4 hours before applying a second coat (if necessary).

SPA CHEMICALS